RXSOL-16-1049-020 is a concentrated solvent emulsion cleaner for cleaning of Air coolers, Scavenging air systems and turbochargers of the diesel engine.
ACC9 marine ship maintenance air cooler cleaning chemicals supplier in Mumbai – JNPT, GOA, Manglore, Gandhidham Kandla, Mundra, Sikka, Surat, Chennai – ennore, Visakhaptnam – Vizag, Gangavaram, Kolkata – Haldia, Paradip Keeping ready stock. And also providing materials to all near by port.
Formulated to remove oil, grease & carbon deposits from air coolers & scavenging system
- Efficient and economical.
- May be used for in-service cleaning.
- Renders surfaces oil-repellent.
- Maintains and stabilizes air cooler efficiency at a maximum.
- Saves time, maintenance costs and avoids risks of damage when dismantling.
- Leaves no residue and has no harmful effect on the engine.
- Product in water solution is non-flammable, non-explosive and has no flash point.
- Can be used for light carbon removal from machinery parts
**Read the Material Safety Data Sheet before using this product**
Water Treatment Chemicals – Raw
Boiler Water Treatment Chemicals
Cooling Water Treatment Chemicals
STP Treatment Chemicals
ETP Treatment Chemicals
Water Treatment Chemicals
MUNICIPAL water treatment chemicals
MINING & MINERAL PROCESSING
RO Membrane Treatment Chemicals
Sugar Process Chemicals
Paper Process Treatment Chemicals
In-service cleaning%u2013RXSOL-16-1049-020 is passing through the air trunking upstream of the charge air cooler, followed by a clean water rinse.For cleaning of air coolers, it is necessary to use correctly installed dosing and injection system.
Hand spray Cleaning:-
By Hand spray, apply concentrate RXSOL-16-1049-020 all over the cooler coils. for good emulsification & penetration. Allow the RXSOL-16-1049-020 for a minimum of 1 hour, then use a high pressure water to wash off the loosened deposits. During process always keep drain valve open. After satisfactory cleaning, and flushing through with fresh water, close air cooler drains.Note that during this process the engine must be stopped.
Soak method :
Machine parts with stubborn carbon deposits to be cleaned is dipped into conc. Soln.of ACC then allow deposits too. Be broken down and loosened before removal, then rinse.
3 to 5 litres of cleaning solution per square meter or as table below:
|Engine HP.||Solution of 10 to 25% RXSOL-16-1049-020|
|6,000 to 12,000||2 to 3 litre|
|12,000 to 24,000||4 to 5 litre|
|24,000 or more||6 litre|
For cleaning of Air cooler and Air side of turbochargers, a solution of 5 – 25% RXSOL-16-0009-ACC in fresh water is recommended. Inject the solution for 10-15minutes, then similar quantity of fresh water injected to rinse off emulsifieddeposits.
Note: This article uses material from the http://rxmarine.com/