Currently browsing: Foundry Ind Chemicals

RXSOL Silica Sol 30%

Silica Sol has many applications for paper, fibers, steel and catalysts. Most recently, it has been used by the semiconductor industry as a polishing agent for silicon wafers. Without the development of chemicals such as Silica Sol, the electronics industry would not be where it is today. Silica Sol comes in a variety of types to suit your needs…..

Read more

Silica Sol RX

Particles and Surface State

Silica Sol made by growing mono-dispersed, negatively charged, amorphous silica particles in water. OH ions exist at the surface of the particles with an electric double layer formed by alkali ions. Stabilization is achieved by the repulsion between the same negatively charged particles. Disturbance of the charge balance will cause the Silica Sol to aggregate, resulting in high viscosity or gelation of the solution.

Stability

Effects of pH change

The higher …..

Read more

Zircon

Zircon's exceptional qualities of hardness and durability makes it a must-use for the manufacture of ceramics and refractory tiles and also for a range of other high-tech applications such as armour plating on military aircraft, heat shield in space shuttles and potentially as solid oxide fuel cells in hydrogen powered vehicles and in many industrial and chemical applications. Owing to its chemical inertness, very low heat conductivity, high specific gravity, low expansion, good resistance to ab…..

Read more

ACID Slurry LABSA 96 to 98 60 Kg

USAGE of LABSA: The product can be used as the raw material to produce kinds of detergent, emulsion such as laundry powder, dish wash cleaner in daily chemical industrial.
CHARACTERISTIC : Our products has high action of detergency, moistening, Foaming, emulsion. It is brown viscous fluid in appearance with acidity and strong absorbency. Packing Details: 210KG Net Plastic Drum or according to customers' requirements…..

Read more

Corrosion Inhibitor

Storage and Disposal

Acid corrosion Inhibitor RXSOL-16-1047-210 and will not freeze at temperature as low as -20° Fahrenheit. Below 0° Fahrenheit,Acid corrosion Inhibitor RXSOL-16-1047-210 become very viscous and may be difficult to pump. It is recommended that Acid corrosion Inhibitor RXSOL-16-1047-210  be stored in a dry area where the temperature will not go lower than 0° Fahrenheit.

Applicable regulations concerning disposal and discharge of chemicals should be consulted and followed-

…..

Read more

Aqua Break RX 20 Ltr

WHY RXSOL-16-3003-020 is better ?

An economical  highly concentrated product.
Compatible with oily water separators.
Releasing the oil phase for reclamation.
Suitable for all types of floors. Deodorizing nature.
Eliminates the need to buy & stock duplicate products because of its effectiveness.
Also used for gas and hydrocarbon freeing of tanks. Free from caustic & hydrcarbon, Non flammable Water based, Biodegradable. Safe to metal
 …..

Read more

Aqua Break RX 25 Ltrs

Method of Application and Doses:- 
1st of all by stripping suction removes all possible oil (greasy materials). To prevents evaporation of lighter fraction oil flush the system with cold water.May be brushed on, sprayed (Hand spray/Direct injection) recirculate  the system with RXSOL-16-3003-025 Solution

1.

Cleaning with   washing machines. Dose rate: 0.3-5 ltr per ton wash water (0.03-0.5%).     

2.

Cleaning with recirculation method. Dose rate: 0.5-10 ltr per ton wash water, (0.05-1…..

Read more

AQUA Tuff High Foam conc.

Cleaning agents used in Aquatuff  for hold cleaning solution is fully biodegradable and not be harmful to the marine.  Allow the Aquatuff High foam solution to act for 10-20 minutes thereafter wash the chemicals with high pressure. Due to compatibility and non hazardous nature of Aquatuff makes it superior all purpose cleaner for tank and cargo hold cleaning to essential maintenance tasks in the engine room, or general cleaning of crew and galley areas, every cleaning task.
Heavy Soil deposit…..

Read more

Rocor NB Liquid With Indicator 25 Ltr

…..

Read more

Bentonite Soil Conditioning Agent

Bentonite can be Broadely classified in 2 grades :
 
Granular: Granular is the preferred option for filling trenches where the conductor is covered with Bentonite and then water poured over and mixed in the trench.
 
Powder: Powder is the preferred method for pouring into bore holes to en-sure the mixture is of a thin enough consistency to reach the bottom of the bore hole. If diamond drilling is required for deep holes, possible 40m depths and deeper and the Bentonite is to be pumped throug…..

Read more

Bentonite Powder

Bentonite can be Broadely classified in 2 grades :
 
Granular: Granular is the preferred option for filling trenches where the conductor is covered with Bentonite and then water poured over and mixed in the trench.
 
Powder: Powder is the preferred method for pouring into bore holes to en-sure the mixture is of a thin enough consistency to reach the bottom of the bore hole. If diamond drilling is required for deep holes, possible 40m depths and deeper and the Bentonite is to be pumped throug…..

Read more

Conductivity Powder

The specification is as below :-

 

Natural graphite – 20%

Sodium bentonite – 30%

Gypsum powder – 10%

Megnatite –  2%

Cadmium  – 10 ppm

Lead – 22 ppm

Mercury – 10 ppm

Chromium – 5 ppm

Monobromobyphenyle – 3 ppm

 

Electrical conductivity – 1 ohm

 

After making gel mixture with water ,  conductivity is below 1 ohm. …..

Read more

Resuscitate Acid Cleaner

Cleaning of equipment such as pasteurizers, sterilizers and evaporators by removal of salts, lime and rust spots. Also it renews the appearance of ceramic tile, porcelain tile, grout, granite, slate, and sandstone. It is also biodegradable and emits fewer vapors than typical acid cleaners. …..

Read more

Natural Blue Biodegradable cleaner and Degreaser

Storage and Handling :

Store product in the unopened container in a dry location. Optimal Storage: 8 °C to 21 °C. Storage below 8 °C or greater than 28 °C can adversely affect product properties.Material removed from containers may be contaminated during use. Do not return product to the original container. Rx Marine International cannot assume responsibility for product which has been contaminated or stored under conditions other than those previously indicated. If additional information is…..

Read more

Methanol Water Mix

Methanol Reformer Fuel Specification : The First Element Methanol Reformer fuel mixture is 66% Methanol / 33% Distilled Water on a volumetric basis. The mixture is prepared in a blend tank of suitable volume. The selected blend tank must be thoroughly cleaned and free of all contaminants. Ensure the mixture is sufficiently blended to produce a homogeneous mixture. …..

Read more

Hand Cleaner Paste, Waterless 1 Kg Pkg

Avoid contact with wounded skin
Super tough premium industrial waterless hand cleaner gel , uses orange / lemon  peel extract , effectively remove wet paint, printing inks, greases, Oil, Adhesives, grime, Carbon black, glue and several other to remove most stubborn Hand cleaner manufacturer and exporter from India , for Wholesaler and Trader  Greaseless, waterless hand cleaner. ; Fresh orange / lemon scent; Contains no petroleum distillates to dry out skin Hand Cleaner Gel is not flammable and…..

Read more

Truck Wash Brightener

Dilute with water before using. The level of dilution depends on the nature and the temperature of the surface being treated.
Can be applied by brushing or high pressure spray wash.
Always Work from bottom to top both on application and rinse. Allow the solution to work for 10 minutes or less prior to rinsing.
Recommended concentrations are 10:1 dilutions for brush application and 20:1 for pressure washing application.
Do not permit solution to dry on surface, rinse completely and preferably by …..

Read more

TRUCK Mounted Cleaner Descaler

Dilutions rates recommended : 
Light Duty Cleaning      : 500 Gram  : 4 Ltrs WATER
Normal Cleaning           :  1 Kg  : 4 Ltrs WATER  15 minutes  or  Time duration can be increased up to 45 minutes for Heavy deposit cleaning.
Heavy Duty Cleaning    : 1 Kg  : 4 Ltrs WATER   15 minutes…..

Read more

Ultrasonic Bath Universal Cleaner

As the name this is universal cleaner and suitable for claening of equipments, tools, surface etc. Make sure the surface of objects is completely immersed. Hollow objects have to be immersed in a way that air can completely escape from the cavities. Concentration and time of application depend on type and degree of contamination. After cleaning, rinse parts thoroughly with water. For spotless drying, rinse with demineralised water. Respirators (face masks) and protective work equipment have to…..

Read more

FORE and AFT

For cleaning of hard surfaces, such as decks, tanks, engine-rooms, etc. These two steps are followed:
High Molecular mixture of CATIONIC and ANIONIC surfactant, to react with all oil and grease molecule
 

Step

1:

Spray directly on area to be cleaned

Step

2:

With high-pressure clean entire emulsified area

Due to high emulsification & penetration objects achieves optimal cleaning results.
Due to repulsion activity fore aft-Rx preventing dirt from reformin…..

Read more