dvr Toilet Bowl Urinal Cleaner Disinfectant Gel

Urinal Cleaner is specialized product for Decalcifier/Rust remover.  Concentrate Cleaner Liquid for Sanitation system toilet bowls and urinals. Its full strength will allow to loose and disolve worst build up of organic soils. Allow this product to remain for at least 10 minutes until all rust, scale and deposits are loosened.  Rinse by flushing.
 

Generic Name:

Sanitation system Decalcifier, Rust remover

Technical Specifications:

 

Phase White gel
Fragrance Characteristic
pH Less than 1.0
Density 9.6#/gal.
Acid content 20.0% min. HCL
Stability 2 yr. minimum
Detergency Excellent
Viscosity thin 10 cps
Rust removal Excellent
Flash point None

Toilet Bowl Urinal Cleaner Disinfectant Gel supplier in Mumbai, Gandhidham, Chennai, Kolkata, Visakhapatnam, Fujairah – Dubai, Middle East.

Application:

Start the cleaning operation under the rim of the commode or top rim of the urinal using the side of the applicator.  Force the bowl cleaner up and in to the water outlet holes allowing the product to run down the sides of the bowl or urinal.  This will allow the full strength product to come into direct contact with the areas most likely to have the worst build up of organic soils.  Proper disinfection requires a thorough cleaning of the trap area as well as the bowl.  If you have done a proper job of forcing all the standing water out, you should have no trouble swabbing the trap and bowl without the product becoming diluted.  Allow this product to remain for at least 10 minutes until all rust, scale and deposits are loosened.  Rinse by flushing.  Use a germicidal cleaner for the seat and outside areas – do not use this product on any surface outside the commode or urinal.

 

Using Procedure:

Allow this product to remain for at least 10 minutes until all rust, scale and deposits are loosened.  Rinse by flushing.  Use a germicidal cleaner for the seat and outside areas – do not use this product on any surface outside the commode or urinal. To clean and disinfect both toilet bowls and urinals – first, remove standing water by forcing it up and over the trap area with swab mop.  Wring excess water out of the swab mop and saturate with bowl cleaner.

Note: This article uses material from the http://rxmarine.com/