dvr Oxygen Scavanger Plus

Oxygen Scavenger Plus is a catalysed liquid solution of Hydrazine and  diethylhydroxylamine (DEHA). Its volatile properties ensure distribution throughout the boiler and condensate system, and hence protects against oxygen corrosion in all parts of the system. The product also provides the required conditions for the establishment of a passivating layer of magnetite on all inner surfaces. RXSOL-50-5022-025 is a low toxicity product, suitable for high, medium and low pressure boiler systems.

Technical Specifications:

 
Product Specifications:

Density 

1

Packing, Type

PLASTIC

Volume

25 l

pH

10.5

Colour 

LIGHT YELLOW

Appearance

LIQUID

Directions for use
This product is formulated for use in conjunction.Oxygen Scavenger Plus can be used in any boiler system, and in conjunction with mechanical deaeration systems. Removal of dissolved oxygen is vital for prevention of corrosion and especially pitting corrosion in boilers. When dosed into a boiler system, Oxygen Scavenger Plus will react with dissolved oxygen and form non corrosive compounds. The product is volatile, and left over product from oxygen scavenging in the pre-boiler section will evaporate and assist protection of the steam and condensate system. No solid materials are produced when using Oxygen Scavenger Plus.
 

Dosing method
Rx Marine International recommends continuously into the boiler feed line and Boiler Water Treatment Dosing Unit.
Dosing should be controlled so that the DEHA residual in the condensate is between 0.08-0,30 ppm. The consumption will depend on feed water temperature and the amount of water fed into the boiler. For more information about initial dosage and dose rate please consult your nearest Customer Centre.
Test result condensate PPM DEHA   
0.00 – 0.08 0.08 – 0.30 0.30 +
Increase dose 25% Maintain dose Decrease dose 25%

Sampling and testing
A representative sample of Condensate should be drawn for analysis daily. The sample should always be taken from the same sampling point, cooled and tested immediately By Rxsol Test Kit. It is important that regular testing is carried out, to ensure the correct level of treatment is maintained.
 

Features
%u2022 Fast acting, liquid oxygen scavenger.
%u2022 Safe and easy to use, low toxicity.
%u2022 Reduces corrosion of iron and copper, increasing system life and reliability.
%u2022 Neutralises acids occurring in condensate system.
%u2022 Volatile product, provides distribution and protection throughout the boiler system, economical in use.
%u2022 Suitable for use in conjunction with combined and co-ordinated treatment programmes.
%u2022 Organic product, no dissolved solids added.
%u2022 Simple test to determine treatment level. 

Using Procedure:

Directions for use
This product is formulated for use in conjunction.Oxygen Scavenger Plus can be used in any boiler system, and in conjunction with mechanical deaeration systems. Removal of dissolved oxygen is vital for prevention of corrosion and especially pitting corrosion in boilers. When dosed into a boiler system, Oxygen Scavenger Plus will react with dissolved oxygen and form non corrosive compounds. The product is volatile, and left over product from oxygen scavenging in the pre-boiler section will evaporate and assist protection of the steam and condensate system. No solid materials are produced when using Oxygen Scavenger Plus.
 

Dosing method
Rx Marine International recommends continuously into the boiler feed line and Boiler Water Treatment Dosing Unit.
Dosing should be controlled so that the DEHA residual in the condensate is between 0.08-0,30 ppm. The consumption will depend on feed water temperature and the amount of water fed into the boiler. For more information about initial dosage and dose rate please consult your nearest Customer Centre.
Test result condensate PPM DEHA   
0.00 – 0.08 0.08 – 0.30 0.30 +
Increase dose 25% Maintain dose Decrease dose 25%

Sampling and testing
A representative sample of Condensate should be drawn for analysis daily. The sample should always be taken from the same sampling point, cooled and tested immediately By Rxsol Test Kit. It is important that regular testing is carried out, to ensure the correct level of treatment is maintained.
 

 

Application:

RXSOL-50-5022-025 The objective is to maintain a hydrazine residual between 0.05-0.2 ppm depending on operating pressure and boiler designe. Actual consumption is determined under operating conditions. A normal dosage is approximately 1 ltr. per day, depending of system layout.

Hydrazine is a convenient reductant because the by-products are typically nitrogen gas and water. Thus, it is used as an ANTIOXIDANT, an oxygen scavenger, and a corrosion inhibitor in water boilers and heating systems. 

Hydrazine is mainly used as a foaming agent in preparing polymer foams 

TESTING PROCEDURE ::: http://rxmarine.com/hydrazine-test-kit

TEST METHOD ::: http://rxmarine.com/hydrazine-test-kit

Note:

Features
%u2022 Fast acting, liquid oxygen scavenger.
%u2022 Safe and easy to use, low toxicity.
%u2022 Reduces corrosion of iron and copper, increasing system life and reliability.
%u2022 Neutralises acids occurring in condensate system.
%u2022 Volatile product, provides distribution and protection throughout the boiler system, economical in use.
%u2022 Suitable for use in conjunction with combined and co-ordinated treatment programmes.
%u2022 Organic product, no dissolved solids added.
%u2022 Simple test to determine treatment level. 

Note: This article uses material from the http://rxmarine.com/