dvr Lac Alka Liquid HD 25 Ltrs

Well balanced heavy duty alkaline tank cleaner. A very strong alkaline lac cleaner, which can be used to soften up and cleaning of drying / non drying fats oils and also used after animal and vegetable oils, fish oils, tall oils, tung oil etc. It is free hydrocarbon solvents.Gentle & sutable for tank cleaning operation.   It's natural based detergent product have an exceptional solvency power on soil & oily  matter. It is free from Hydrocarbon solvents , Biodegradable and minimizes the extreme hazards to personnel in handling materials.

We are LAC Alkaleen liquid Tank Cleaners manufacturers in india. And holding no-1 position for LAC Alkaleen liquid Tank Cleaners suppliers in kandla, mundra, chennai, ennore, vizag, kakinada, jnpt, manglore, kolkata, haldia, paradip, dubai, fujairah, sharjah.  Alkaleen Liquid Heavy Duty concentration makes surface clean easily and effectively.

Technical Specifications:
  • Removes grease, oil, carbon deposits, soil and grime.
     
  • Keeps loosened deposits in suspension preventing re-deposition.
     
  • Low toxic.  , Non-flammable.
     
  • Free from hydrocarbon solvents.
     
  • Effective and economical in use , Water-based cleaner.
     
  • RXSOL-20-2015-025 has numerous cleaning applications including removal of greases, waxes,
     
  • oil, sludge, soot, carbon   deposits and general dirt and grime.
     
  • Non-corrosive to ferrous metals.  Suitable for all tank-coatings.
     
  • Can be used for gas and hydrocarbon freeing of tanks.
     
  • Can be used for deodorizing
     
  • Contains wetting agents.


NOTE : Acts as an acid-neutralizing agent.

Application:

It can be used as a general purpose cleaner to remove oil and grease deposits.First of all flush the system with cold water to prevent evaporation rates and polymerization then the most economical method of using RXSOL-20-2015-025 is by direct injection followed by recirculation washing, using tank cleaning machines. Spraying Method  – Using LAC as delivered in drums, spray onto areas where residue remains following rough washing leave for 10-45 minutes (but do not allow to dry), then butterworth at maximum pressure and warm water 60oC for at least 3 hours, checking that there is no foam remaining in the final stages.  Inspects tanks(s) and if desired result has been achieved fresh water rinse and dry.

** Make sure to take all safety precautions are followed when handling / spraying RXSOL-20-2015-025

Injection Method %u2013 not applicable.

Note:

Re-circulation Method :
Fill tank with fresh water and heat up to warm 50 oC .IF a drop line is available on the tank line system, then start to circulate the water and add the required amount of Caustic flakes and LAC to make a 2.5% solution.  A stronger solution can be made, but be advised that too much Caustic and too high temperature will result in white powder all over the tank.  Under normal circumstances, between 2.5% and 4.5% will be sufficient strength.  If there is no drop line, then lower butterworth hoses into the tank from the pump stack header without machines attached and circulate through these hoses while you fill the solution material.

* Use a strainer at the pump stack when circulating any solution.*
  Tank Lining %u2013 Stainless / Epoxy / Phenolic

Note: This article uses material from the http://rxmarine.com/