Coldwash degreaser supplier and exporter. Coldwash easily emulsifies oil grease from engineering and rigs platform and surface.
Cold Wash is classified Cleaning Chemicals and degreaser. Due to the presence of
|Appearance||Clear amber brown liquid|
|Density||In g/cm3 at 15°C: 0.95b|
|Flash Point||Above 70°C ( on dilution with water more than 90°C )|
|Metal||No known effect|
|Synthetic rubber||May swell|
|PACKAGING||Order No: RXSOL-20-2003-210||
Size (in litres): 25,/30,/210
AVOID contact of RXSOL-20-2003-210 with skin or eye Contact. If contact occurs wash with ample quantity of water. NOTE : on dilution RXSOL-20-2003-210 is more effective and safe for use on epoxy, polyurethane, zinc-silicate coatings and stainless steel.
RXSOL-20-2003-210 is a heavy duty highly concentrated and economical emulsifier. Safe to use on most metal surfaces, painted and coated surfaces and also used as a multipurpose degreaser in extremely hard cleaning conditions.
Treated for the really tough daily cleaning problems faced in the proper Maintenance of Industrial and Institutional physical plants. Can be used as a stripper for all types of waxes and finishes and as a Degreaser where regular cleaners will not perform. Maybe brushed on, sprayed or used in a dip tank. Excellent for use as a wash for fuel tankers & as a liquid steam jenny compound.
Ready to use for tank cleaning or general degreasing.
Complete removal of dirt, oil, carbonized grease, heavy oil, gum , vegetable oil , Lube oil, soot , asphalt ,paraffine, carbon stains etc. Gives clear finish to the surface. Highly effective for the removal of crude and other high melting point stains.
PROEDURE OF USE :
|Mix 1 part of RXSOL-20-2003-210 with 2 -10 parts of water / GAS-OIL ( For heavy oil,greasy surface use directly)Spray directly on the entire surface to be cleaned. This can be achieved by Hand spray / mechanical spray pump. Immediately after 2 -5 minted of spray the RXSOL-20-2003-210 starts its function. The Dirt, oil grease etc will loosen. 5 to 6 minutes after spraying start rinsing the system with water (High pressure recommended). Dirt and mud starts vanishing with cleaning media and water|
|Application in immersion process with or without ultrasonic support, manual wipping.|
RXSOL-20-2003-210 is also used in conjunction with alkaline degreasing bath at 2-10% (v/v) concentration for better and quick degreasing action. Eithers the bath is heated to be 70°Cor the solution can be stirred or air agitated. FINALLY RINSE THE SYSTEM WITH FRESH WATER.
RXSOL-20-2003-210 is easily soluble in water Action is quite fast even at low temperature which gives advantages of cleaning under operation And avoid shut down and down time.Non corrosive to most of the metals / plastics. Gives clear finish to the surface .Lower cost due to high concentration
Note: This article uses material from the http://rxmarine.com/